Bottle Lock Funny Gift Whisky Contraption 3D Printer Model
The file 'Bottle Lock Funny Gift Whisky Contraption 3D Printer Model' is (stl) file type, size is 28.9KB.
The file 'Bottle Lock Funny Gift Whisky Contraption 3D Printer Model' is (stl) file type, size is 28.9KB.
Hi,
this is simple funny contraption lock for bottle of whisky or other booze. It's not meant to be hard, but can take some time to unlock. Simple design: print 1 cap and 2 plates, you only need to supply M4 threaded rod ( for 28cm tall bottle you would need 2x1m of rod) , some m4 nuts and you are ready to go, (optionally epoxy glue).
Can be adjusted to different heights, max diameter is 9cm (near the lower lip, actual max diameter between rods is 9.5cm).
In lower plate nut would recomment to use epoxy glue. There is deep groove for nut, but if you want to be 100% cheater proof small drop cannot hurt you.
| cap.stl | 60.0KB | |
| plate.stl | 112.4KB |
