Made for Gliński's hexagonal chess, also compatible with McCooy's variant.
https://en.wikipedia.org/wiki/Hexagonal_chess
Uses 5x1mm magnets or optionally no magnets.
Matching chess set (without magnets): https://www.thingiverse.com/thing:4901226
Or one of the Remixes to use magnets:
5x1mm (same as this design):https://www.thingiverse.com/thing:4948374
10x2mm: https://www.thingiverse.com/thing:4923919
Print 3 of part 1, 3 of part 2. 30 white tiles, 30 black tiles, 30 gray tiles and finally 3 of the center tile (magnet goes into just one of the thirds). Affix to board in the pattern as seen in the fourth picture, they all have the same pattern of grey-white-black tiles.
Magnets in the tiles are embedded so, for example, in Cura at 0.2mm layer height you need to pause at layer number 16, put in the magnets, then continue print. Recommended to use a dummy body (just a cylinder or whatever) that gets printed first after the unpause to prime the nozzle again after being paused.
| Hexagonal_chess_board.f3d | 1.7MB | |
| Hex_Chess_Board_-_Center_tile_-_5x1mm_Magnet.stl | 6.4KB | |
| Hex_Chess_Board_-_Hexagon_tile_-_5x1mm_Magnet.stl | 14.7KB | |
| Hex_Chess_Board_-_Part_1_-_5x1mm_Magnet.stl | 53.8KB | |
| Hex_Chess_Board_-_Part_2_-_5x1mm_Magnet.stl | 55.9KB | |
| Hex_Chess_Board_-_Version_without_magnets.zip | 15.8KB |
