Z3CUPHOLDERASSY MUST BE SCALED BY 2540% TO PRINT AT THE CORRECT SIZE, I'm not sure why Creo Parametric exports the models so small I will try to work it out.
This uses part #51168217953, this replaces my original design that was a standalone print cup. I found the cupholder in the junkyard and decided to adapt it
I'll upload some pictures of it installed in my car when I get around to it
This uses four screws (m4 I believe) drilled into the plastic console for a more secure connection, instead of a printed clip that could fatigue and break
If printing the assembly, orient it so that the flat of the mount is on the bottom as shown
| z3cupholderassy2.stl | 404.0KB | |
| z3cupholdermount.stl | 142.3KB | |
| z3cupholderv4.stl | 13.9KB |
