BMW Z3 and M, E36/7, longer Seatbelt Guide Fix
Idea came from https://www.thingiverse.com/thing:4894695 by Papa_Oso. If you want to buy a pre-printed piece with his original design, please support the original idea and design by visiting Papa_Oso's store.
etsy.com/shop/BMWZ3Shop
ebay.com/usr/joshlk
I found that the original design although works, is not long enough in my car and that it would slide over time. I cant remix it, so I re-measured and re-created a similar but overall different model with different geometry from scratch, and after a few trial and error, I ended up with this geometry and length.
I have had great results from PETG then painted with black bed liner. I didnt have black PETG handy, and I wanted a little more sun and heat resistant so I painted it with the bed liner. I suppose you wouldn't have to paint it at all. I made it at 100% infill, since its small, but a lower infill should suffice. Should be an easy print. Ender 3 V2, 245C/75C, no support.
| Seatbelt_Remixed_Filet.STL | 504.0KB |
