BlueSCSI Mac SE – SD Extender Mount 3D Printer Model
The file 'BlueSCSI Mac SE – SD Extender Mount 3D Printer Model' is (stl,HEIC) file type, size is 2.7MB.
The file 'BlueSCSI Mac SE – SD Extender Mount 3D Printer Model' is (stl,HEIC) file type, size is 2.7MB.
This is a mount created for the BlueSCSIv1/v2 or SCSI2SD to use an SD card extender to route the SD card slot to the back.
There are other models that allow you to put the entire card in the PDS slot of the compact Macs, however my particular model has dual floppy drives and an aftermarket hard drive sled, so there is simply not room to have the entire board behind the PDS cutout.
The SD card extender can be held on with double sided tape. This should fit an extender with or without a case.
I only have a Mac SE to test with, but I suspect this will fit the slot on any of the compact Mac models.
| BlueSCSI_v2_SE_SD_Extender_Mount.stl | 13.2KB | |
| IMG_9290.HEIC | 2.7MB |
