Continuing in the B's we have the BloodHound. Like some of the previous cards, this one posed a challenge due to the unique shading of the card. I found that when I kept myself limited to the same thickness as the other cards, I was forced to use red on a layer I would have preferred not to. But in the end, it gives it a nice menacing look to it.

The Pelts and Holographic cards will be done closer to the end. Ill need to figure out good colors for them.

Feel free to share. The source of the original image can be found in the link below.

https://cards.vladde.me/

Ive been pretty busy making these. However, I dont like uploading files until ive printed it successfully at least once.

This time around im not including the 3mf file and instead you will need to follow the directions of the "_describe.txt" file for instructions on what layers to swap the colors at.

You will need to reduce the size of the model. I would suggest reducing the X and Y by 50%, but make sure to leave Z at 100%. If you modify the Z attribute the instructions will not be valid.

Printing Tips - I would highly suggest reducing the print bed temps from your usual settings when printing with PLA. High temp beds tend to make the corners curl. I would also suggest using a print adhesion product of some kind to help it stick. These are 4 hour prints, and it sucks to have it ruined by a bad corner.