This mounts the Blink Mini on the tube of a Creality 3D printer enclosure.
I have my printer in the garage and when it is not printing, I swing the camera around to see if the garage door is (forgotten) open.
I have included the screw that holds the Blink Pan unit to this.
I use a 7/32 drill bit to clean up the hole for the gopro bolt to go through. You don't have to but then it slows down the treading process.
PETG
20% infill.
The clamp for the tube is my https://www.thingiverse.com/thing:6596882.
If you need gopro type extension bars and stuff look at;
https://www.thingiverse.com/thing:62800
by MoonCactus.
there are about 200 pages of remixes off of MoonCactus designs.
Mine is not a remix but I do use a couple of his extension bars.
I have included the two knobs that I used, they are standard GoPro style knobs so you can use the ones you already have or others that you might find in Thingverse.
| 6_GoPro_2.stl | 39.6KB | |
| GoPro_knob_knurl_long.stl | 587.5KB | |
| GoPro_knob_knurl_short.stl | 182.6KB | |
| short_screw.stl | 43.3KB |
