Custom case for Atem Mini and Monitor.
For more information on the parts needed for this case and how to build it, check out my full blog post here: https://dslrvideoshooter.com/atem-mini-case/
Watch video demo of the case here: https://youtu.be/I9qHchu2m7Y
I printed all of my parts on a Prusa i3 MK3 in PETG and PLA with no issues.
If you plan on using this case outdoors or in high temperatures (think hot car in the summer) you should consider using ABS or PETG.
All STL files are in the correct orientation for printing. Just throw them in your slicer as is.
The following parts should be printed with supports turned ON:
| clamp-v1.stl | 52.3KB | |
| face-plate-center-v1.stl | 52.3KB | |
| face-plate-top-left-v1.stl | 143.8KB | |
| face-plate-top-right-v1.stl | 144.7KB | |
| hdmi-out-mount-v1.stl | 10.4KB | |
| hdmi-out-mount-with-holes-v1.stl | 36.3KB | |
| monitor-mount-long-v1.stl | 33.4KB | |
| monitor_mount_short-v1.stl | 33.3KB | |
| support-corner-top-left-bottom-right-slim-v1.stl | 83.1KB | |
| support-corner-top-right-bottom-left-slim-v1.stl | 83.1KB |
