Very Simple and Basic Battery Wall mount / holder for wall or Van

Made for 18V Black Decker Battery

Battery fits snug so wont fall out easily, charger can be plugged in to battery whilst battery is in mount. Some similar designs on thingiverse but ones I printed were a little tight or not quite right so I just started new design.

2 screw holes on design, Use flat head screws and dont force screws after they've gone as far as they need to so they are flat to the mount design (not blocking battery sliding in)

I printed in PLA - naturally will crack with too much pressure when screwing in - basically stop screwing when there is resistance :-)

Short Video showing its use on streamable link here: https://streamable.com/xrd08e

I'm using a Flashforge AD3 and took about 5.5 hours with 20% infill