This is simple bisection of Thing: 850829, ZbrushBatRemix by JustinTolman
In one piece, the bat requires crazy support, but I chopped it at an angle that allows each half to print WITHOUT SUPPORT!
I added sticky pads at the end of the wings to minimize any curling. Glue together and then trim flush.
Hope you like!
zbrushbatremix_back_half.stl | 967.3KB | |
zbrushbatremix_back_half_pads.stl | 984.6KB | |
zbrushbatremix_front_half.stl | 1.6MB | |
zbrushbatremix_front_half_pads.stl | 1.7MB |