Birdhouse for small birds like titmice or parus.
Many models here are to small or even dangerous for birds, so i decided to create the better one.
- Enought space for baby birds
- Minimum surface and infil for best thermal isolation.
- Rain protection design.
- Holes in top and bottom for good airflow.
- Size of the main entrance protect small birds from the bigger one.
- Chamber is deep enough to protect birds from predators (like cats).
- In front of the entrance is a small “bridge” where bird can check if it is save outside.
- Entrance can easely turn to the oposite of main wind direction
With two screws mount holder to the tree. Then just mount the Birdhouse
Birds need some quite place. Without peoples or other animals. Best is the tree in the corner of the garden.
Minimum distance from two birdhouses is 50 meters
It’s important to hang birdhouse min. 2 m high from the surface. Think about if the predators can’t reach the bird house upon branches.
Don’t put the birdhouse right to the sun shine. It can easely overheat.
Printed on YSoft Be3D - EDEE
| BirdHouse-botom.stl | 3.3MB | |
| BirdHouse-holder.stl | 267.1KB | |
| BirdHouse-middle.stl | 682.8KB | |
| BirdHouse-top.stl | 2.2MB |
