The model is rather big, so I printed scaled it down 80%.
Model needs some more work - the middle part's walls are a bit too thin on top, may break off if the cap is stuck. The clearance between the bottom and the middle parts to be reduced, now it slides off too easily.
Update: our town updated the bylaw regulating the wild life feeding.
This feeder potential locations are hard to protect from the squirrels, so no reason to improve it any further.
| Bottom.stl | 727.1KB | |
| Bottom_3_Ports.stl | 1.4MB | |
| Bottom_3_Ports_No_Support_Needed.stl | 1.4MB | |
| Cap.stl | 250.0KB | |
| Middle.stl | 405.4KB |
