Printed without supports.
After printing remove the bridges on the clips of the lid to make them flexible.
If you want to use seeds for feeding you could hollow-print the file "Einsatz" in transparent PLA/PETG (1 wall line, 0.4mm bottom, 0.0mm top, 0% fill).
Cut out the lower columns so that the seeds could flow out.
| Deckel_v1.stl | 1.3MB | |
| Einsatz.stl | 345.7KB | |
| Pin.stl | 2.2KB | |
| Unten_v1.stl | 1.3MB |
