This is a simple bird cage using standard 1.75mm filament (pre-extruded) as bars.
I originally began the design to accommodate my file Perched Dragon.
NOTE: The top and bottom look similar but are not. Top has a hole for suspending the cage and a hook for suspending the ring perch. The bottom has a hole for the T perch.
BE SURE THE DOOR FRAME HINGES POINT UP TOWARDS THE TOP. Otherwise the door will fall off when you open it.
The door has a simple snap fit to close.
Accessories include 2 perch types and a dish.
I have included a three part version of the center ring for printing on small platform printers.
Because the print uses 1.75mm filament as the bars do not scale the parts or the bars will no longer fit.
| bottom.STL | 3.8MB | |
| chassis_L.STL | 183.2KB | |
| chassis_R.STL | 182.5KB | |
| chassis_whole.STL | 1.3MB | |
| dish.STL | 85.8KB | |
| door.STL | 480.2KB | |
| doorframe.STL | 1015.0KB | |
| perch.STL | 6.9KB | |
| perch_base.STL | 3.8MB | |
| ring_perch.STL | 317.1KB | |
| top.STL | 4.5MB | |
| topnoring.STL | 4.1MB |
