[edit 08.03.2023]
I have added V2
The fences are now only clips for the side and no longer attached to my base module.
I have added a pin to be able to switch the suet ball holder and my new water station (which comes now with a bottle).
But all is still work in progress and will be tested.

[edit 23.01.2023]
I have added a fence version for a suet ball holder (see picture).
The sued ball holder I used was from a different site. but you can probably use this one:
https://www.thingiverse.com/thing:5770148
But consider that my design has no thread therefore you will have to glue the lower part of the suet holder.

First at all as I could not add the remix source files I used the following sources:

https://www.thingiverse.com/thing:5754727
https://www.thingiverse.com/thing:5707127
https://www.thingiverse.com/thing:4693696
and the original stl provided by bird buddy in the facebook group "Official Bird Buddy Community"

My goal was to have an add-on with a fence where the birds will hopefully position in front of the camera. My second thought was that I like to have the fence as individual files that I will not have to print the whole thing complete (and waste filament because of the support). And to have one version with a water source where the birds will be also in front of the camera to drink and eat.

This is marked as "in work" as I have encountered some issues:

• The pole to give the fence a bit more stability is a bit too long - but this is no problem for me (see the pictures if this will e a problem for you - you will have to decide)
• The bottle (0,5 liter) I wanted to use for the water source is too high. Therefore I had to cut and glue my bottle that it will fit below the roof (the bottle high should be 9cm or less).