A simple 6cm extension for Bird Buddy accessories. Attaches with an M5 screw and allows accessories to be added at an offset to the factory mount point.
An M5x8x7 heat-inset threaded insert is required. A shorter one should probably be fine.
I am using the ones from this set: https://www.amazon.com/Mardatt-Threaded-Embedment-Assortment-Printing/dp/B08ZHFLDNQ
Depending on filament, the hole for the insert may be a bit small, so so material may have to be cut away (or pushed out with a screw) after insertion.
I recommend printing in ASA for long-term stability, but PLA should be fine for quite a while.
If this is useful for you, please consider buying me a coffee! https://ko-fi.com/grajohnt
| birdbuddy.stl | 672.4KB |
