BIQU Microprobe Mount For Qidi X3 Series. Pictures Are Fitted To X-Smart 3 3D Printer Model
The file 'BIQU Microprobe Mount For Qidi X3 Series. Pictures Are Fitted To X-Smart 3 3D Printer Model' is (stl,FCStd) file type, size is 3.1MB.
The file 'BIQU Microprobe Mount For Qidi X3 Series. Pictures Are Fitted To X-Smart 3 3D Printer Model' is (stl,FCStd) file type, size is 3.1MB.
Mounts to the left side rather than the right to prevent interference with the hot end fan. Goes behind wires going to hot end.
Tool-head Board probe wiring is.
2pin Socket:
3pin Socket:
Important: You need to swap the Black and Red of the 3pin plug on the microprobe over.
Needs modifications to the printer.cfg file. Please see below for guidance (I have re-wrote and split my config up)
Config information is located here:
https://github.com/SmileyMan/Qidi-X-Smart-3-Klipper-Config
My probe config (I have renamed Tool-head Board from MKS_THR to Toolhead):
https://github.com/SmileyMan/Qidi-X-Smart-3-Klipper-Config/blob/main/sub_config/probe.cfg
My bed config:
https://github.com/SmileyMan/Qidi-X-Smart-3-Klipper-Config/blob/main/sub_config/bed.cfg
My homing override code - This ensures Y is homed first and backed off 15mm so micro probe is not pushed against the printer frame:
https://github.com/SmileyMan/Qidi-X-Smart-3-Klipper-Config/blob/main/sub_config/homing.cfg
| qidi-microprobe-mount-volcano.stl | 2.5MB | |
| qidi-microprobe-mount.FCStd | 1.7MB | |
| qidi-microprobe-mount.stl | 2.4MB |
