This is a complete re-design of my original bike console. It will work better on more bikes, the cupholder is more level, and it's able to hold your phone and drink at the same time!
Phone slot is made to fit a Galaxy S10, but can be re-sized pretty easily (.step file is included!) Phone slot has five 3x10mm magnet slots for you to super-glue magnets into. If you've got a plate in the back of your phone (for car magnet mounts) it will grip the phone tight.
There is a slot near the front to strap the whole thing down tight to the bike's handlebar stem. I used a FPV-drone battery-strap but you can use whatever you like really. Even a string with a good knot will work.
There's also a small pocket behind the phone to hold a mask or whatever other trinkets you find on your ride, and drainage ducts so none of the compartments will hold water if you get rained on or your cup starts sweating.
It prints on an angle for extra strength. The cupholder should become level when you install it. Print 2 clips and slide them in underneath of the handlebar on either side to secure it to your bike. Print with NO SUPPORTS. Enjoy!
Original bike console here:
https://www.thingiverse.com/thing:4540271
| Bike_Console_V2.step | 296.4KB | |
| Bike_Console_V2.stl | 217.4KB | |
| clip.stl | 28.4KB |
