A larger version of my paint brush carry case available here.
This version is about the diameter of a mug (~70mm) and has 4 compartments for keeping brushes separated. Its total height is 260mm.
There are 2 versions to the bottom part; one with compartments and another without. The compartments one is useful for keeping brushes that are used for different paints separate.
15/01/2024 V1.1: The pattern on the top tube had areas which were slightly too thin to print, I have adjust theses areas so the pattern is slightly wider so the slicer recognises it. I also made the screw for the bottom tube a bit tighter on the top tube by increasing the diameter from 62mm to 63mm.
06/02/2024 V1.1: Added Hex and Plain Pattern
| Big_Holder_Bottom_Curves_-_No_Compartment_V1.1.stl | 749.6KB | |
| Big_Holder_Bottom_Curves_V1.1.stl | 769.2KB | |
| Big_Holder_Bottom_Hex_V1.1.stl | 595.4KB | |
| Big_Holder_Bottom_Plain_V1.1.stl | 477.4KB | |
| Big_Holder_Top_Curves_V1.1.stl | 1.4MB | |
| Big_Holder_Top_Hex_V1.1.stl | 1.2MB | |
| Big_Holder_Top_Plain_V1.1.stl | 1.1MB | |
| Bottom_Big_Holder.ipt | 923.0KB | |
| Top_Big_Holder.ipt | 16.9MB |
