The file 'Bicycle 3D Printer Model' is (SLDPRT,STL,UPP,SLDASM) file type, size is 8.3MB.
Bicycle printed on a UP! Mini.
It was intended as a trophy for being 12.5 years with the company.
I don't have a race bike nor intend to own one.
I took some information from the net about frames. From there I created a frame, the wheels and the rest. It came out that the front wheel should be smaller as the backwheel... so be it.
Known issues:
Play of the axles in their bearing could be reduced.
Play of the front fork in the frame is OK.
Play of the pedal-axle in the frame could be reduced.
To use an elastic band for a chain, carefully cut the right-rear leg from the frame, put the elastic band over the hubs, than glue it back in place.
The pedal-axles have a press fit into the kranks, holes in the kranks could be a bit larger.
| achterwiel.SLDPRT | 1.5MB | |
| achterwiel.STL | 2.4MB | |
| achterwiel.UPP | 256.0KB | |
| fiets.SLDASM | 1.1MB | |
| fiets_met_standaard.SLDASM | 1.1MB | |
| frame.SLDPRT | 536.0KB | |
| frame.STL | 142.0KB | |
| frame.UPP | 15.4KB | |
| krenk.SLDPRT | 281.5KB | |
| krenk.STL | 243.0KB | |
| Part3.SLDPRT | 509.5KB | |
| Schild.SLDPRT | 552.0KB | |
| Schild.STL | 210.7KB | |
| standaard.SLDPRT | 637.0KB | |
| standaard.STL | 300.7KB | |
| stuur.SLDPRT | 603.0KB | |
| stuur_orientatie_tbv_printen.SLDASM | 223.0KB | |
| stuur_orientatie_tbv_printen.STL | 882.3KB | |
| trapas.SLDPRT | 353.0KB | |
| trapas.STL | 607.3KB | |
| trapper.SLDPRT | 207.5KB | |
| trapper.STL | 109.1KB | |
| trapperas.SLDPRT | 146.0KB | |
| trapperas.STL | 21.4KB | |
| trappers.UPP | 116.2KB | |
| voorvork.SLDPRT | 406.0KB | |
| voorvork.STL | 217.4KB | |
| voorwiel.SLDPRT | 521.0KB | |
| voorwiel.STL | 755.5KB | |
| voorwiel.UPP | 78.8KB | |
| zadel.SLDPRT | 441.0KB | |
| zadel_orientatie_tbv_printen.SLDASM | 194.0KB | |
| zadel_orientatie_tbv_printen.STL | 463.1KB |
