i liked to make bits for beyblades but i could not find any 1 place where i could find most if not all the parts i need to make custom bits.
all you need to customize your bit is stack parts and make sure they are touching the base of the other parts especially with the center ring parts.
if you are not good with 3d editing programs like me i suggest using 3dbuilder as that is free and easy to use.
i suggest printing with a resin printer using tough resin.
i will try and update the file with extra bits when they come out and some experimental inventions of my own.
EDIT:
some custom parts were added
i will keep on adding new parts as loose pieces.
fixed a size issue so now the shaft should sit better and not as loose.
thank you to a-studio and lsc128 for inspiring me to start this project.
| 10_gear.stl | 111.3KB | |
| 10_gear_tapered.stl | 190.7KB | |
| 12_gear.stl | 89.1KB | |
| 12_gear_tapered.stl | 202.8KB | |
| 16_gear.stl | 406.2KB | |
| 16_gear_tapered.stl | 434.4KB | |
| attack_and_balance_type_shaft.stl | 582.5KB | |
| bit_customiser_template_new.stl | 46.0MB | |
| B_stamina_tip.stl | 4.3MB | |
| C_attack_tip.stl | 1.1MB | |
| defence_and_stamina_type_shaft.stl | 393.4KB | |
| disc_bit_ring_from_DB_bit.stl | 823.1KB | |
| D_defence_tip.stl | 9.4MB | |
| E_balance_tip.stl | 3.1MB | |
| FB_Flat_Ball_balance_bit.stl | 3.8MB | |
| free_spinning_shaft_from_FB_bit.stl | 570.6KB | |
| F_attack_tip.stl | 23.3KB | |
| F_attack_tip_with_hole.stl | 68.1KB | |
| GB_stamina_point.stl | 287.1KB | |
| GF_attack_tip.stl | 314.1KB | |
| GN_defence_tip.stl | 631.5KB | |
| GP_balance_tip.stl | 475.8KB | |
| G_stamina_tip_plus_mold.stl | 1.0MB | |
| HB_Hole_Ball_balance_tip.stl | 4.4MB | |
| HT_balance_tip.stl | 85.0KB | |
| H_balance_tip.stl | 253.8KB | |
| low_flat_bit_ring.stl | 442.2KB | |
| MB_Metal_Ball_full_gear_tip.stl | 992.6KB | |
| MB_metal_ball_tip.stl | 833.9KB | |
| missalligned_gear.stl | 1.0MB | |
| nautilus_gear.stl | 1.9MB | |
| normal_bit_ring.stl | 369.1KB | |
| P_balance_tip.stl | 192.8KB | |
| P_defence_tip.stl | 75.8KB | |
| Q_attack_tip.stl | 33.6KB | |
| samurai_edge_tip.stl | 950.6KB | |
| TP_bit_shaft.stl | 3.3MB | |
| TP_Taper_Point_balance_tip.stl | 323.6KB | |
| T_balance_tip.stl | 159.8KB | |
| U_balance_tip.stl | 4.5MB |
