untested as of upload*

while trying to design a beyblade x stadium that was life size i decided to do the inner wall of the corner pockets with a 3d printer over attempting with wood.

this corner pocket is designed as a left and right 2 piece that's glue or other way stuck together to make the inside wall of a 80cm or 800mm diameter stadium area allowing 2/3/4/5/6 pockets and possible up to 8 pockets to give a extreme level to build your own stadiums . each pocket should be between 35mm-50mm deep towards the back wall and 40mm-45mm deep down similar to the takara tomy 2 point knock out zones but wider.

print only takes a couple hours according to my slicer on low res.

included files are left and right sides and also both together.

potential future design for the opposite wall may happen but nothing planned as of this time
may also design the entire stadium to be printed but IMO it doesn't seem worth the time to print when there is the option to purchase a life size stadium with 1000mm/100cm/1m square stadium minus accelerator rail and corner pockets, i don't currently own one but designed this off a 800mm/80cm inner play area which can be adjusted to correct scale in future.

please comment and post pictures if you print this.

files are free to download, edit and share. please do not sell this design for profit but for your cost to print if you must charge but i made these available for free to help further the hobby and bring a little more joy and fun and ask that you try to do the same.