BetaFPV C03 Camera Dummy + Canopy 3D Printer Model
The file 'BetaFPV C03 Camera Dummy + Canopy 3D Printer Model' is (stl,f3d) file type, size is 4.5MB.
The file 'BetaFPV C03 Camera Dummy + Canopy 3D Printer Model' is (stl,f3d) file type, size is 4.5MB.
Update [11/11/2024]: 35 Degree variant is added with some slight improvements. Also increased height a bit to make room for the camera to flex down without hitting the AIO.
Just a simple dummy that people can use as reference and a canopy that works with my Hachidorii line-up of frames.
The canopy only uses three mounting holes that can tightly fit around M2 hardware or can be mounted to regular whoop frames using the usual flange screw most frames come with.
Added some corner guards and a little fin to add some protection to the camera. This canopy also is slightly taller to allow it to flex a good amount before hitting the AIO below it during a direct hit from the top of the canopy.
Highly suggest using tree supports to make removal of supports easier
The .f3d file is also included if you want to modify it but this is far from parametric if youre considering changing the camera angle. I honestly suggest to just add spacers on that front hole if you want to add camera tilt.
| 25_Degree_Canopy.stl | 918.9KB | |
| 35_Degree_Canopy_[C03_With_Fin.stl | 822.6KB | |
| C03_Camera.stl | 73.5KB | |
| C03_Camera_+_25_Degree_Canopy.f3d | 1.8MB | |
| C03_Camera_+_35_Degree_Canopy_C03_Camera.f3d | 2.0MB |
