A new way to store your benchys. Using a variable length pvc pipe of your choice, a few empty spools and 2 barring's (specifics listed below) you can make a spinning tower to hold all your boats. There is also signs to label each benchy if you have different types. Original model made in TinkerCad
26.8mm diamer pvc Pipe. Base will not support a lenght more than 2ft
Small centering ring is measured at 54mm. good for off brand spools.
Large centering ring is measured at 59mm. good for Hatchbox, Amolen, bambu and others.
Bearings used: 608-2rs 8mm x 22mm x 7mm. 2X needed for print.
Also recommended (But not necessary) to drill holes for the poles to screw into. They (quarter storage piece) are loose enough to fall out but not loose enough to slip out from a small spin.
| Benchy_Tower_Abs.stl | 153.6KB | |
| Benchy_Tower_base.stl | 65.5KB | |
| Benchy_Tower_Blank.stl | 8.5KB | |
| Benchy_tower_centering_rings..stl | 50.1KB | |
| Benchy_Tower_PLA.stl | 96.1KB | |
| Benchy_Tower_quarter_no_signs.stl | 202.2KB | |
| Benchy_Tower_quarter_signs.stl | 249.6KB | |
| Benchy_tower_spinner.stl | 103.0KB | |
| Benchy_Tower_TPU.stl | 103.5KB |
