The file 'Ben 10 R.A.T Omnitrix V2 DIY Kit 3D Printer Model' is (stl) file type, size is 2.7MB.
Here's my revised version of my non-accurate omnitrix from Ben 10 Race Against Time, this kit provides everything to make a standard hero version movie prop. That includes:
-display watch
-Button
-Dial
-Icon
-Core
-3 sets of cuffs (full cuff, vertical cut, and horizontal cut)
*THIS VERSION IS A STANDARD HERO VERSION, WHICH DOES NOT HAVE ANY FUNCTIONALITY
Each core set will work with the assembled core but if any resizing to be done you'll need to rescale the entire parts list accordingly. This was made to fit my wrist measurements which is approximately 48mmx63mm measured from top to bottom and side to side of my wrist.
For the core, it's similar to my AF version which is the need to glue the icon down into the core to give the dial rotational motion (avoid getting glue on the dial to prevent bonding). If any parts seem to be a big snug some sandpaper would be advised for better results.
When it comes to attaching it you'll need to find a way to see what can be used to put the cuffs together, for example velcro.
*If you plan on selling physical copies just a reminder to provide credit, Thanks!
R.A.T_V2_button.stl | 86.1KB | |
R.A.T_V2_core.stl | 219.4KB | |
R.A.T_V2_Dial_15.stl | 535.5KB | |
R.A.T_V2_display.stl | 2.0MB | |
R.A.T_V2_full_cuff.stl | 1.3MB | |
R.A.T_V2_icon.stl | 33.4KB | |
R.A.T_V2_set_1.stl | 1.6MB | |
R.A.T_V2_set_2.stl | 1.5MB |