Use two 608 bearings, and a short length of an 8mm smooth rod. Also you will need two M6 bolts & nuts as well as two 4-32 screws & nuts. Installation is easy and does not require any disassembling of the threaded rod frame. Tighten the belt to desired tension and then carefully tighten at the preferred angle with the existing nuts/washers on the threaded rod frame.
| Prusa.Y.Idler.Tensioner.2nd.half.STL | 80.4KB | |
| Prusa.Y.Idler.Tensioner.flipped.STL | 48.3KB |
