Belt Stick 3D Printer Model
The file 'Belt Stick 3D Printer Model' is (STL) file type, size is 484.8KB.
The file 'Belt Stick 3D Printer Model' is (STL) file type, size is 484.8KB.
This is a belt stick used to sand tight corners. This design uses a 319 - 330 mm (12-9/16" - 13") long per 10 mm (3/8") wide sandbelt. The spring is 14.5 mm OD x 12.5 mm ID x 65.5 mm extended length.
It is best printed on its side using support material. The small 5 mm hole running trough the body is to allow air to flow out when submerged in water if PVA is used or D-Limonene if HIPS is used. Other type of non-soluble support can be used but they are going to be hard to remove from the hole.
| BEST01-0001.STL | 904.7KB | |
| BEST01-0002.STL | 459.7KB |
