Beginners Quad 3D Printer Model
The file 'Beginners Quad 3D Printer Model' is (STL) file type, size is 129.5KB.
The file 'Beginners Quad 3D Printer Model' is (STL) file type, size is 129.5KB.
I found this design scurrying around down at the bottom of my hard drive. If I remember right this was a design that I did up right quick to satisfy the pre-rec so I could take the classes to get my drafting certification. This quad was designed to press-fit mount 380 size STANDARD car motors and hold a 1300mah 3 cell LiPoly pack. Although the motor pods do fit on the ends of the arms quite snugly a dab of glue wouldn't hurt ta just keep em on there good an tight. You'll also need 8 small bolts (sorry, don't remember the size of these) and you'll also need a couple of bolts with wingnuts or thumbscrews for the battery strap. Assembly requires that the arms go in-between the chassis plates. NOTE The motor pods have a hole at the bottom for motor wires to lead through but this may be too small for some wire packs but I'll fix this as soon as I get the chance after break.
| arm.STL | 15.1KB | |
| battery_strap.STL | 84.5KB | |
| lower_chassis_plate.STL | 107.7KB | |
| motor_pod.STL | 244.3KB | |
| upper_chassis_plate.STL | 113.6KB |
