Beetle Stop Entrance 3D Printer Model
The file 'Beetle Stop Entrance 3D Printer Model' is (STL) file type, size is 57.5KB.
The file 'Beetle Stop Entrance 3D Printer Model' is (STL) file type, size is 57.5KB.
A new concept to stop Hive beetles entering hives with a 45 degree pipe.
This is a two piece approach and I can make this into a three piece approach by using a PCV cap and cutting it in half. All items are available at the hardware store.
I can make this as a bolt on but I assume you will push a tiny section of 1 inch pipe into the hole you cut in the hive and then attached the main part.
Part B slips over Part A.
I was not able to catch a swarm and try this. Please comment if it works the same as the retail versions. Instead of aiming down, I can add a cover so you can turn it horizontal sideways. so rain will not go into the entrance.
| Collar_part_b_beatle_Stop.STL | 32.5KB | |
| mainpart_a_45_beatle_Stop.STL | 155.2KB |
