The file 'Beer Ingredient Tap Handles 3D Printer Model' is (stl) file type, size is 511.1KB.
I remixed 2 other tap handles on here for the hop and wheat taps, and I created the water and yeast taps to make a set. The holes are set to be just slightly smaller than the required 5/16" so you can run a bit through to clean it up and then tap it with a 3/8-16 tap for the proper threads.
The yeast tap I used the cura "stop at height" function to swap filaments. Enjoy!
If you have any questions let me know but i'm learning 3d modeling as i go so i'm not flawless in any way.
Relax! Have a Homebrew!
hops_tap_handle_flat_v1.stl | 361.5KB | |
water_tap_handle_skinny.stl | 717.1KB | |
Wheat_Tap_Handle_v2_v0.stl | 420.9KB | |
yeast_tap_handle.stl | 417.8KB |