It's always handy to have a box for moving or storing your bee hive frames, and this thing is for converting any suitable sized box into one... add a couple of wooden supports to the box and then screw on the appropriate frame supports!
I've included a range of frame supports for 2 to 9 frames - combine a couple to match the size of your box. My box could fit 9 frames, but my printer wasn't big enough for a single support, so I used a 4 and a 5.
Note: there's a small lip to raise the frames slightly off the support to make it easier to get your (gloved) fingers underneath - make sure the lips are facing each other, otherwise it won't work!
The attached supports have 39mm between each frame (because that worked perfectly for my box) but if you want them further apart just use the customiser and create your own.
| Bee_box_frame_holder.scad | 1.3KB | |
| Bee_frame_2.stl | 48.6KB | |
| Bee_frame_3.stl | 93.1KB | |
| Bee_frame_4.stl | 96.3KB | |
| Bee_frame_5.stl | 99.4KB | |
| Bee_frame_6.stl | 143.9KB | |
| Bee_frame_7.stl | 147.0KB | |
| Bee_frame_8.stl | 191.6KB | |
| Bee_frame_9.stl | 194.6KB |
