Remixed this originally so it would fit my bedframe (84mm frame), then I started playing with it a bit more, adding a USB cable slot on the topside of the table. This would allow form multiple USB cables to come up through the hole for charging.
After THAT it appeared that I had to see if I could reduce the amount of filament used, which then I opened up the sides that made a large opening through the middle, allowing for cables to be tucked into to avoid the 'wires hanging down' look.
I also had the clearance underneath to double-side tape my powered USB hub, allowing for ALL of my devices to cleanly be plugged in. They're like $8 on Amazon https://a.co/d/geeqjlV
Fits PERFECTLY and is sturdy as hell!
Cheers!
| BedSide_Table.stl | 738.6KB |
