Made for 220x220 or bigger beds, this level test discs use a square area of 180x180mm.
The discs have 0.2mm height and thus should be used with layer height of 0.2mm, you can then check the printed discs height to confirm if you the nozzle at the correct height.
Discs printed with values too lower than 0.2mm will cause elephant foot effect and discs printed with values higher than the 0.2mm may have adhesion problems.
The discs size is 20x20mm.
Enjoy and post your results!
If you found my Things useful, treat me to a cup of coffee :)
| 1_point_bed_level_test.stl | 36.4KB | |
| 4_points_bed_level_test.stl | 145.4KB | |
| 5_points_bed_level_test.stl | 181.7KB | |
| 8_points_bed_level_test.stl | 290.7KB | |
| 9_points_bed_level_test.stl | 327.0KB |
