The file 'Bearded Gnome 3D Printer Model' is (stl) file type, size is 2.4MB.
Print each part, see print instructions.
Cut away the wall from the beard with a knife.
Assemble the parts and then use a hair dryer/hot air gun to slowly heat up the beard while you use a hand to form it (use lowest setting). It's also possible to use warm water.
Be careful not to burn yourself.
Tip: put the hair dryer on the edge of a table so you can use both hands.
After you have formed the beard, you can use scissors to make some final adjustments.
The base of the hat is symmetric so you can print a mirrored version if you want some variation.
Support / Reseller
If you want to support me or sell my models, take a look at my Patreon:
https://www.patreon.com/thomash3d
You can also send me a tip on paypal:
https://www.paypal.me/thhen
Extra pack
Want some more variation?
Buy the extra pack.
https://www.cgtrader.com/3d-print-models/house/decor/bearded-christmas-gnome-extra-pack
The extra pack is included in the commercial tier on my Pateron.
beard.stl | 1.2MB | |
body.stl | 1.5MB | |
hat.stl | 3.3MB | |
nose.stl | 491.9KB | |
pin.stl | 31.1KB |