Battery Cover Vanmoof S2/X2 3D Printer Model
The file 'Battery Cover Vanmoof S2/X2 3D Printer Model' is (obj,stl) file type, size is 187.6KB.
The file 'Battery Cover Vanmoof S2/X2 3D Printer Model' is (obj,stl) file type, size is 187.6KB.
To replace broken battery cover on my S2 bike. I think it will also fit the S3 (let me know)
You have to replace the 3 inserts 2xM5 (side) and 1xM6 (middle) by reusing the originals or buy new ones.
The slit offset of the middle is to facilitate the battery cable not getting squeezed.
Caution !! the middle screw is to support the battery and needs to be carefully adjusted. If thightend too much you will pierce the battery. First install cover and adjust middle screw. After adjusting install side screws.
| Mafoo_v18.obj | 535.5KB | |
| Mafoo_v18.stl | 297.2KB |
