This battery case can be printed in several parts if your printer is not big enough to do it in one time.
It fit 2 batteries pack like this :
Spec.
Capacity: 5000mAh
Voltage: 3S1P / 3 Cell / 11.1V
Discharge: 25C Constant / 35C Burst
Weight: 354g (including wire, plug & case)
Dimensions: 162x21x46mm
Balance Plug: JST-XH
Discharge Plug: 5.5mm Bullet
You can find them on hobbyking.
two packs connected in serie, will make a 6S 5000mah pack.
Should be enough for 10km range.
| boitier_2parts.FCStd | 217.3KB | |
| boitier_batterie.FCStd | 136.3KB | |
| couvercle_batt.stl | 19.4KB | |
| demi_boitier_arr.stl | 67.5KB | |
| demi_boitier_avant.stl | 82.9KB | |
| demi_couv_arr.stl | 9.7KB | |
| demi_couv_avant.stl | 10.8KB | |
| Pattes_seulement.stl | 60.6KB |
