Note of warning: Since this is just basically a remix of arhis' model, it carries the issue I had with his model. Cover is a tight fit, the hinges will not even go in the cover to lock the case. I just trimmed it off. I think if you adjust the cover to be 1mm or 2mm bigger it would work well. If I wanted to print another one, i'll do just that. But no time to update the stl now.
Don't get me wrong, the cover works, just don't close it fully, otherwise it would be too hard to remove the cover.
| Box_10aa_4aaa.stl | 771.7KB | |
| Cover_10aa_4aaa.stl | 52.0KB |
