Bat’leth And/or Mek’leth Wall Display 3D Printer Model
The file 'Bat’leth And/or Mek’leth Wall Display 3D Printer Model' is (stl) file type, size is 56.2KB.
The file 'Bat’leth And/or Mek’leth Wall Display 3D Printer Model' is (stl) file type, size is 56.2KB.
After making my own Bat'leth and a pair of Mek'leths, I needed a way to artistically display them for all to see. The widest part is the circular base which is 300mm across. Feel free to scale the entire thing accordingly.
It should hold any full-size Bat'leth and Mek'leth. I designed it to hold a Bat'leth sized according to the original concept drawing. The pins will fit into the outer handles if they are 12" or less apart and they will fit within the middle handle if it's more than 14" wide. Keep those values in mind if you have to scale the entire mount to fit on your printer.
There are two holes on the back for mounting. The intent is to place two screws into a stud in the wall. The display should hang from the top screw while the bottom screw keeps it vertical.
If you want to display just a Bat'leth or just a pair of Mek'leths, select the appropriate wings and spire top.
| Base.stl | 53.4KB | |
| Batleth_and_Mekleth_Left_Wing.stl | 27.0KB | |
| Batleth_and_Mekleth_Right_Wing.stl | 28.5KB | |
| Batleth_only_Spire_Top.stl | 6.0KB | |
| Batleth_Pin.stl | 5.0KB | |
| Mekleth_only_Left_Wing.stl | 20.7KB | |
| Mekleth_only_Right_Wing.stl | 22.2KB | |
| Mekleth_Spire_Top.stl | 19.9KB | |
| Spire_Base_Pin.stl | 484.0B | |
| Spire_Bottom.stl | 5.8KB | |
| Spire_Pin.stl | 484.0B | |
| Wing_Pin.stl | 484.0B |
