Bat Signal 3D Printer Model
The file 'Bat Signal 3D Printer Model' is (stl,ipt) file type, size is 1.1MB.
The file 'Bat Signal 3D Printer Model' is (stl,ipt) file type, size is 1.1MB.
This batsignal was designed to be lit. There are holes to run the wires through and the base is large enough to house a battery. The only piece not there is the clear lens for the bat symbol to be attached to. I will just cut out some clear plastic from packaging.
Well, after printing my own I discovered that the connector pieces from the main housing to the bracket were too big. I sanded them down and it fit better. I also found out that ABS doesn't have much flex to it. I did snap one of the bracket pieces trying to get it on. I CA glued it back and it functions fine. Also the back piece ended up printing into two pieces which means I'll just have to glue it on when the time comes. I did delete the old file and replaced it with a new file that should print as one piece.
| BatBase.stl | 418.8KB | |
| BatBracket.stl | 382.8KB | |
| BatGlass.stl | 950.1KB | |
| BatSignal.stl | 604.7KB | |
| BatSignalBack.ipt | 497.0KB | |
| BatSymbol.stl | 81.3KB |
