This is a Remix from ( https://www.thingiverse.com/thing:4541362 ) Basketball Hoop Toy for Parrots.
I Made the base the same size, but added a 45* Bevel at the top of the top of the base. I also put a 2.5mm hole in the top of the base to Accept the Pole so it could be glued in but make it easier to print. Resized the pole to 4.75mm x 55mm. And added a new pole 75mm for Bigger birds.
Resized the Backboard and added a 2.5mm hole in the bottom of the board to slide over top of the pole to be glued in, giving it more stability.
Left Hoop same size.
Resized basketball to 20mm x 20mm x 20mm.
This should make it easier to print out and be more stable when glued together.
You can use Superglue or IF you are careful you can use Hot Glue which would give more stability but could melt the base some as the glue is HOT.
| Basket_Ball_Hoop_Parrots_Backboard.stl | 14.3KB | |
| Basket_Ball_Hoop_Parrots_Base.stl | 5.3KB | |
| Basket_Ball_Hoop_Parrots_Basketball.stl | 1.3MB | |
| Basket_Ball_Hoop_Parrots_Hoop.stl | 274.3KB | |
| Basket_Ball_Hoop_Parrots_Pole_55mm.stl | 12.4KB | |
| Basket_Ball_Hoop_Parrots_Pole_75mm.stl | 12.4KB |
