Base For Tower Lamp 3D Printer Model
The file 'Base For Tower Lamp 3D Printer Model' is (stl) file type, size is 818.2KB.
The file 'Base For Tower Lamp 3D Printer Model' is (stl) file type, size is 818.2KB.
Added a cover for the lamp designed again in Tinkercad see poly twist.stl
The base with the triangle corners does not print properly - the triangles seem to be protruding below the base of the thing like stilts - use the one with square corner posts.
I made this to fit a spiral vase accordion tower with 81mm square base to turn it into a lamp.
The base has a lid with 42.5mm hole into which a 230mm plastic pipe can be slotted - the pipe holds an LED strip wrapped around it - the wires from the strip feed through the hole to the electronics in the base - there is a 8mm diameter hole for fitting a PSU panel jack.
The top is a push fit into the base - might need a minute bit of sanding.
The new top part now has a built in tube.
Thanks to CADNurd for his accordion vase which I used to make my lamp
https://www.thingiverse.com/thing:4852334
Added a centre pole with a spiral slot for the led strip which holds 56 leds from a WS2812B 60/m strip
Added two new covers
| 82mm_stand_base.stl | 16.8KB | |
| cover02.stl | 1.2MB | |
| cover03.stl | 62.7KB | |
| for_82mm_lamp_42mm_hole.stl | 34.8KB | |
| poly_twist.stl | 40.9KB | |
| repaired_base_with_triangle_conners.stl | 18.2KB | |
| spiral_led_pole.stl | 474.2KB | |
| toptowerpart.stl | 61.2KB |
