Banana Tracker V1 3D Printer Model
The file 'Banana Tracker V1 3D Printer Model' is (zip,stl,stp,step) file type, size is 9.4MB.
The file 'Banana Tracker V1 3D Printer Model' is (zip,stl,stp,step) file type, size is 9.4MB.
Frame for an antenna tracker built around 0.75" square dowel and a lazy-susan bearing from Home Depot. Free-rotating end uses a press-fit skate bearing. Servos are mounted using exterior mounting tape. Plywood base is 1/2" thick sheets.
The length of the pitch bracket is so that the CG of a mounted Ubiquity Nanostation is balanced along the axis of the pitch servo.
Servos: http://www.hobbyking.com/hobbyking/store/__28972__HobbyKing_8482_High_Torque_Servo_MG_BB_W_Proof_12_8kg_0_22sec_58g.html
But may fit output shafts from other servos. Shafts are press-fit into 3D-printed brackets and gears.
Designed in Inventor 2016 and Onshape. Inventor source files, STEP, and Onshape link provided.
| Banana_Tracker_v1_Base_-_Inventor_2016.zip | 2.1MB | |
| Base_Large_Gear.stl | 1.1MB | |
| Base_Large_Gear.stp | 608.7KB | |
| Base_Small_Gear.stl | 1.3MB | |
| Base_Small_Gear.stp | 389.7KB | |
| Bottom_Bracket.step | 318.3KB | |
| Bottom_Bracket.stl | 2.3MB | |
| Pitch_Driven_End.stl | 1.8MB | |
| Pitch_Free_Bracket.step | 57.8KB | |
| Pitch_Free_Bracket.stl | 1001.0KB | |
| Pitch_Free_End.stl | 2.7MB | |
| Pitch_Servo_Bracket.step | 860.2KB | |
| Pitch_Servo_Bracket.stl | 7.5MB | |
| Tracker_Pitch_Driven_End.step | 230.9KB | |
| Tracker_Pitch_Free_End_-_Right.step | 375.8KB | |
| Yaw_Servo_Bracket.step | 52.1KB | |
| Yaw_Servo_Bracket.stl | 137.7KB |
