For SunLu Standard PLA, PLA+ spools. Note: SunLu PLA Matte spools will not work on this

BBLamsL_Sunlu_Spool Holder v1
Use on original free standing AMS lite only. v1 has no tab to prevent slipping if the AMS angled top mount mod is used. v2 has a tab included to prevent original spindle from slipping out. Use v2 if using the top mount mod.

*.20mm Standard for quality.
Standard settings for Generic PLA filament use should be just fine.
Enable support. Use defaults. Do NOT check "On Build Plate Only"
Seams: Aligned

BBLamsL_Sunlu_Spool Holder v2
Use on any AMS lite. v2 has a tab included to prevent original spindle from slipping out. The tab has a 5mm gap of play so you can push the original spindle out and twist using the gap for finger grip which helps slip the original spindle out easier. A v3 is being test printed for less gap.

*.20mm Standard for quality.
Standard settings for Generic PLA filament use should be just fine.
Enable support. Use defaults. Do NOT check "On Build Plate Only"
Seams: Aligned

On the P1P, approximately 62g of filament is used. Total time 1h43m stock settings.
On the A1, Approximately 57h of filament is used. Total time 2h26m using stock settings.

File can also be downloaded from my Maker World https://makerworld.com/en/models/627988

I do have a v3 that pulls up the gap I allowed for v2 and is a great fit, it just does not allow for ease of removal of the original spindle like v2 does. If you want v3 stl, message me.