This is an Air puck/hovercraft is used with a balloon to have fun with a low friction device. This takes only a few hours to print and needs only a balloon and a smooth surface. (I can get 50 9" balloons for $1 at my local dollar store)
Note: Be sure to get the flared out section inside the balloon just above the neck. This will give best results. Also I find it easiest to attach if I blow the balloon up the twist the end a few times to help seal the air while attaching.
I went through a few versions of this with my daughter to achieve the best results. If you have any feedback, please let me know in the comments.
| AIRPUCK5.stl | 5.0MB |
