Balance Lamp 3D Printer Model
The file 'Balance Lamp 3D Printer Model' is (stl) file type, size is 1016.1KB.
The file 'Balance Lamp 3D Printer Model' is (stl) file type, size is 1016.1KB.
I was inspired bij the Heng Balance Lamp by Zanwen Li on Instagram.
This was made of wood but I found no 3D-printed derative so I made one.
I made parts for little and bigger printers.
Print parts:
Materials used:
Assembling:
The light caps can be printed in different color and fit tight in the frame, no glue required.
The caps also hold the ledstrip in place and are a bit overlap with the seams for strength.
After assembling I melted the links inside with a soldering iron for better bonding which are covered bij the led strip and light caps.
Tight the ropes to the upper half, inside with knots (and/or glue) and couple the other half with the magnets and 3 pins tightly.
At the top I used a little of the support from the caps (2 cm) and punched a hole for the rope and put it behind and between the upper 2 curve caps so it won't fall off.
| Base_bottom.stl | 129.7KB | |
| Base_housing.stl | 633.2KB | |
| Base_switch.stl | 151.4KB | |
| Base_top.stl | 411.2KB | |
| Half_curve.stl | 159.5KB | |
| Magnet_close.stl | 979.7KB | |
| Magnet_hole.stl | 989.1KB | |
| Mount.stl | 14.3KB | |
| Pin.stl | 100.1KB | |
| Quarter_curve.stl | 79.8KB | |
| Quarter_curve_cap.stl | 76.4KB | |
| right.stl | 7.5KB | |
| right_cap.stl | 1.4KB | |
| test1.stl | 7.5KB | |
| test2.stl | 1.4KB |
