Contains a Two Piece Upgrade for the modern HO Scale Bachmann 4-8-4 GS-4 Daylight to make the single headlight setup into a dual headlight setup. The Headlight Mount is swapped for the new one, and will fit two 3mm LED's. The second piece is a light separator. to fit this you need to remove the Clear Lens piece and cut it into 2 pieces, which you can then slide through the front of the boiler face and position them as needed. Then you put the light separator in the inside of the boiler face and press till it's flush.
as a side note, to avoid needing more than 6 tender to loco wires, its recommended to wire a decoder buddy mini inside the loco, originally where the resistor pcb was, reroute the motor leads and route two speaker wires to the tender/loco pcb, and wire accordingly.
Makerworld link: https://makerworld.com/en/models/628986#profileId-553689
| Bachmann_GS4_Headlight_Seperator_Final.stl | 44.4KB | |
| Bachmann_GS4_Headlight_Upgrade_Final.stl | 71.6KB |
