2024/03/31 edit, added two simpler versions:
I designed this as an improvement over the original battery compartment lid of the Skywatcher AZGTi mount.
The AZGTi_lid.stl offers:
This lid allows me to use the same cables that I use for my AZEQ6. Additionally, with regards to my setup, I can:
If you want this exact design, you might need to refine some parts a little bit. Also, I discovered that maybe not all LM2596 breakout boards are the same. This model might not be 100% accurate for your board.
Consider that the "tooth" or clip is not alligned to the face of the lid. Therefore you can't print it flat, it is required to keep it standing up. Support needed for the clip and the two little indent
| AZGTi_lid+base.stl | 144.3KB | |
| AZGTi_lid.stl | 196.0KB | |
| AZGTi_lid_only.stl | 98.7KB |
