Small part (32 minutes, 6g, 2.04m) to test the radial gap between parts as 0.5 mm
(print without support and adhesion by standard [fine - 0.2mm] settings)
1) but set the Wall Ordering - Outside To Inside
2) but set the Z Seam Alignment - Shortest
Result: The axle dangles quite freely after being removed from the table.
same part as v1, but with radial gap 0.3 mm.
Result: The axle almost not dangles after being removed from the table.
<<< we are here >>>
| axle_v1.f3d | 63.3KB | |
| axle_v1.stl | 160.1KB | |
| axle_v2.f3d | 62.8KB | |
| axle_v2.stl | 148.6KB |
