Axial Unimog SCX10.II Snow Plow 3D Printer Model Free Download

Description Files (13)

Summary

This is a snow plow for the Axial SCX10.II (SCX10.2) Unimog UMG10.

Theoretically, this should bolt on to any SCX10.II axle and frame, but you'll need some shims/washers for the upper frame mount maybe.

I added the Winch mount version which i had forgotten to upload!

Bolts to the axle for best strenght when pushing snow.
Upper frame for a servo mount, required only if you don't have a winch or something else to raise the plow.
Has a set of shoes that are height adjustable.
The lower frame has a set of M3 screws that you can adjust to limit the blade angle to what you like.
It should not restrict your turn radius unless you have big tires.
I added a hard link and a "snake" link that hopefully will allow those without springs or shocks to still use the plow. If the "snake" is too hard, print it thinner until you get the correct flex that you need!
You only need one of these: "Plow_Upper_Frame_Servo" or "Plow_Upper_Frame_Winch" depending what you use to lift the plow. If you already have a winch attached you dont need ANY of these two and no Frame Mount either.

Requires :

45mm pull spring or a shock in droop setup that pulls instead of push, for the plow safety mechanism. You can use a hard link if you want.
Dozen M3x20 screws
Couple M3x16 screws
Handfull of M3 nuts
Servo or winch

Hard_LInk_46mm_OPTIONAL.stl	48.1KB
Plow_EdgeOptional.stl	151.6KB
Plow_Lower_Frame_Adjustable_SCX10.II_v2.stl	236.4KB
Plow_Upper_Frame_Servo_SCX10.II_v2.stl	152.9KB
Plow_Upper_Frame_Winch_SCX10.II.stl	88.8KB
Plow_v5.stl	479.9KB
SCX10_II_Axle_Mount_Left_v2.stl	131.6KB
SCX10_II_Axle_Mount_Right_v2.stl	131.6KB
Shoe_Left.stl	45.7KB
Shoe_Right.stl	45.7KB
Snake_Link_46mm_OPTIONAL.stl	146.7KB
Unimog_Frame_Mount_Left_v3.stl	99.1KB
Unimog_Frame_Mount_Right_v3.stl	99.1KB