Axial Scx10iii Cj7 Rear Sway Bar 3D Printer Model
The file 'Axial Scx10iii Cj7 Rear Sway Bar 3D Printer Model' is (STL) file type, size is 9.8KB.
The file 'Axial Scx10iii Cj7 Rear Sway Bar 3D Printer Model' is (STL) file type, size is 9.8KB.
Rear sway bar designed for the axial scx10iii cj7. The printed parts are designed to be used in conjunction with the traxxas parts listed below as well as 3mm and 2.5mm hardware. The sway bar will utilize the screw holes that go through the frame into the rear bumper mount. The holes in the printed sway bar arms undersized so you can run a drill and tap through them before threading a bolt into them.
TRA8598 (Traxxas UDR sway bar set)
TRA2742 (Traxxas rod ends)
TRA2537 (Traxxas Threaded Rod Set)
m3x20mm bolt (2 bolts for mounting through the rear axle truss).
m3x15mm bolt (2 bolts for mounting the rod links to the swaybar arm).
m3 nut (4 nuts for the bolt that goes through the axle truss).
m3 washer (2 washers are optional and go between the nut and the axle truss.)
m2.5x10mm bolts (clamp bolts for the sway bar to arm connection).
The sway bar ends (part number TRA8598) will need to be modified to not exceed the diameter of the bar. This is very easy to do with a Dremel or bench grinder. Only the front Traxxas UDR (shorter swaybar) is used.
| 14.5mm_wide_spacer.STL | 16.5KB | |
| Axial_CJ7_Swaybar_Arm.STL | 32.6KB |
